Universal Remote Control ATLAS 5-DEVICE Bedienungsanleitung PDF herunterladen (Seite 11)

www.urcsupport.com

RE-ASSIGNING DEVICE KEYS

The Potenza ST Universal Remote Control can be set up

to control a second device of an already-assigned type.

For example, to have the unit control a TV, a set-top box,

and two audio devices (for example, two audio

receivers), re-assign the unused VCR key to operate the

second audio device as follows:

NOTE: VCR is preset at the factory to control an RCA

VCR. Performing the steps below will over-

write those settings.

The VCR key is now ready to be programmed for your

second audio device. See “Programming Device

Control” on page 9. To re-assign other device keys,

repeat these and substitute the key sequence using the

following chart:

NOTE: Only one device can be assigned to an unused

device key at a time.

4. Press and hold SETUP until the STB key blinks

twice.

1. On the remote control, press VCR once; it will

blink once. Then press and hold SETUP until

the VCR key blinks twice.

2. Enter 9 9 2. The VCR key will blink twice.

3. Press AUD once, then press VCR once. The VCR

key will blink twice.

To Re-Assign Perform Key Sequence

VCR as 2nd

AUD key

VCRÆSETUPÆ9Æ9Æ2ÆAUDÆVCR

VCR as 2nd

TV key

VCRÆSETUPÆ9Æ9Æ2ÆTVÆVCR

VCR as 2nd

STB key

VCRÆSETUPÆ9Æ9Æ2ÆSTBÆVCR

VCR back to

VCR

VCRÆSETUPÆ9Æ9Æ2ÆVCRÆVCR

Nebula Potenza ST.fm Page 23 Monday, October 15, 2007 4:55 PM

1 2 ... 6 7 8 9 10 11

Keine Kommentare

Universal Remote Control ATLAS 5-DEVICE Bedienungsanleitung Seite 11