Universal Remote Control ATLAS 5-DEVICE Bedienungsanleitung PDF herunterladen (Seite 15)

www.urcsupport.com

Deleting All Learned Keys in a Specific Mode

NOTE: If more than 15 seconds pass between key

presses, the remote exits programming.

PROGRAMMING CHANNEL CONTROL LOCK

By default, the remote control’s channel-control

capabilities are locked to the cable converter. The

affected keys

are 1 through 0, CH+, CH-, ENTER, and

LAST. This will guarantee that you do not inadvertently

change a channel on your TV or VCR. However, you can

de-activate this feature to allow full access to these keys

in the TV and VCR modes.

NOTE: This feature does not affect the AUD mode.

Unlocking Channel Control

Now the remote control will provide TV and VCR

channel-control capabilities while in the TV or VCR

mode.

1. Press and hold SETUP until the last-selected

mode key blinks twice, then press 9 7 5.

2. Press a mode key twice (i.e., AUX, DVD, AUD,

TV, or CBL) to clear all the learned keys for

that mode. The LED blinks twice.

3. Repeat step 2 for another mode or press and

hold SETUP to exit programming.

1. On the remote control, press CBL once; it will

blink once. Press and hold SETUP until the

CBL key blinks twice.

2. Enter 9 7 3. The CBL key will blink twice.

3. Press CH- once. The CBL key will blink four

times.

Atlas M11055 Rev 2.fm Page 15 Thursday, September 22, 2005 12:55 PM

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 71 72

Keine Kommentare

Universal Remote Control ATLAS 5-DEVICE Bedienungsanleitung Seite 15