Universal Remote Control CONTROL WR7 Bedienungsanleitung PDF herunterladen (Seite 29)

Page 29

OSD (On-Screen Display) Control ‘Punch Through’

This ‘punch through’ enables you to program the WR7 so that

CBL or DVD OSD Controls (MENU, GUIDE, INFO, EXIT, SEL and

4 Cursor Controls) will also operate in other component modes

on the remote control.

STEP 1: Press and hold the component button you want to

add OSD Control to, such as [TV] or [VCR], and the SELECT [SEL]

button at the same time for two seconds until the Component LED

light turns on.

IMPORTANT: You have 30 seconds to perform the next step

while you are in programming mode. If you do not press a

button within 30 seconds, the component LED light will turn off.

The remote will exit the programming mode and you will have

to start over.

STEP 2: Press the [MENU] button. The component LED will

blink once.

STEP 3: Press either the [CABLE/SAT] or [DVD] button that

you want to use as the source of OSD Control. The component

LED will blink three times to confirm it is saved.

SELECT

COMPONENT

BUTTONS

WR7 1/13/08 12:18 PM Page 29

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 48 49

Keine Kommentare

Universal Remote Control CONTROL WR7 Bedienungsanleitung Seite 29