10 WATT BACKPACK SYSTEM
Portable LOS command and control communication
system for field operations, it uses rechargeable
NiCad batteries. A backpack is available for storing
necessary accessories for portable operation and is
excellent for use in emergency situations where rapid
“jerk and run” communications is a necessity.
TYPICAL 10 WATT BASE SYSTEM
For LOS air-to-ground or ground-to-ground command and
control communications from a non-mobile base station, this
station is used with a powerful, dual-band discone antenna
to maximize communications range. It can be powered via
any AC voltage from 85VAC to 250VAC or, through use of
the UDD100A, by any DC voltage from 10VDC to 20VDC.
TYPICAL 50 WATT BASE SYSTEM
For LOS air-to-ground or ground-to-ground command
and control communications from a non-mobile base
station, this system is used with a powerful, dual-band
discone antenna to maximize communications range. It
also features a 50W(FM)/30W(AM) RF amplifier to boost
your signal for even greater range capability and can be
powered via any AC voltage from 95VAC to 265VAC.
10 WATT MOBILE SYSTEM
This system is used for LOS air-to-ground or ground-
to-ground command and control communications
from mobile platforms. Accessories allow mounting
and remote control in just about any type of mobile
platform: Automobiles, trucks, APCs, boats, etc. The UVU-
110S Antenna Kit can be used in any light duty mobile
system that has a 12-volt DC supply. If a 28-volt DC
supply is available, the DC/DC supply is not required.
TYPICAL 50 WATT MOBILE SYSTEM
From a mobile platform, this system provides LOS air-
to-ground or ground-to-ground command and control
communications. It features a 50W(FM)/30W(AM) RF
amplifier to boost your signal for even greater range
capability. The system is powered from a 12-volt DC to
28-volt DC High Power Converter that allows installation
into automobiles, trucks, APCs, boats, etc. If a 28-volt
DC supply is available, the converter is not required.
TYPICAL REPEATER/RETRANSMIT SYSTEM
This system allows the user to extend the range beyond
LOS. Located on a mountain top, the URC-200 repeater
system will extend the range by receiving a signal at one
frequency from a user below and then will retransmit at a
second frequency to a user on the other side. This system
can also be used as a cross band repeater with transmit
and receive or receive and transmit at different frequency
bands and modes: Transmit at VHF/AM and receive at
UHF/FM and vice versa. Excellent for operations where
different users operate at different frequencies and modes,
it can also be installed in an aircraft as a flying repeater
to further extend the range. All radio frequency extension
and encryption options can be used in this system.
REMOTE CONTROL OF THE URC-200 TRANSCEIVER
An operator can set the key performance parameters
(frequency, mode, power, etc.) on the radio, then as required,
the operator can transmit/receive through the radio. The
radio system can be installed as either a 10 Watt or 50
Watt system with the addition of a power amplifier. This
provides a solution for air traffic command and control
communications as well as other applications where it
is not possible to have the operators near the radio.
Application Descriptions
(49 Seiten)
(52 Seiten)
(48 Seiten)
(16 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern