Universal Remote Control URC-SR3 Bedienungsanleitung PDF herunterladen (Seite 12)

Page 12

If Auto Search did not work, try this:

Programming URC-SR3

using the Learning Method

STEP 1: Line up the URC-SR3 to the remote control

you want to ‘learn’ from, head--to--head as shown

below. Make sure the heads are one to two inches

apart.

STEP 2: On the URC-SR3, press the Component

button that you want to program (in this case the

button that says TV) and the ENTER [ENT] button at

the same time. Hold down both buttons for 2

seconds until the TV Component button light turns

on. This signals that you are in programming mode.

IMPORTANT: You have 30 seconds to perform

the next step while you are in programming mode.

If you do not press a button within 30 seconds, the

component LED light will turn off. The remote will

exit the programming mode and you will have to

start over.

STEP 3: Press any button on the URC-SR3 that you

want to teach a command to. For example, if you

want to teach the MUTE button on the URC-SR3 the

TV Mute command from the other remote, first

press the MUTE button on the URC-SR3 and the TV

component button LED light will blink once

indicating that the URC-SR3 is ready to learn the

command.

STEP 4: Press and hold the MUTE button on the

other remote until the component button LED on the

URC-SR3 blinks twice. Now you can continue

learning all other buttons from your old remote by

pressing the next button on the URC-SR3 and

repeating this step.

Note: The component LED will blink five times if

there was an error in the learning process. In this

case, please repeat Steps 3 and 4.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 43 44

Keine Kommentare

Universal Remote Control URC-SR3 Bedienungsanleitung Seite 12