Universal Remote Control URC-SR3 Bedienungsanleitung PDF herunterladen (Seite 13)

Page 13

STEP 5: Once the URC-SR3 has learned all the

buttons in the selected component mode, press and

hold the Component button and ENTER [ENT]

buttons at the same time to save the learned

functions. The component LED light will blink three

times to confirm the programming. Now test all the

buttons to make sure they learned correctly.

Repeat Steps 1-5 to program any other component

modes.

If the Learning Method does not work, here are a

few suggestions:

• If you have a LCD TV, move to another room.

• Avoid programming under fluorescent light or

direct sunlight.

• Put new batteries in the old remote.

• Gradually vary the distance between the

two remote controls.

• Tap the button on your old remote instead of

pressing and holding it during the learning

process.

Here are some additional facts regarding the

Learning process:

• Learned functions override any existing

pre-programmed functions on the remote control.

• Learned functions are automatically erased when

a new function is learned on the same button.

• Learned functions are retained even after a

different set-up code number is programmed

into the remote control.

• To return to an original pre-programmed

function, a learned function must to be erased.

PLEASE DO NOT RETURN

THIS PRODUCT TO THE STORE

PLEASE CONTACT OUR TECHNICAL

SUPPORT CENTER

IF YOU NEED ASSISTANCE, E-MAIL

or dial 1-800-901-0800

(9:00AM-6:00PM EST)

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 43 44

Keine Kommentare

Universal Remote Control URC-SR3 Bedienungsanleitung Seite 13