Universal Remote Control MX-800 Bedienungsanleitung PDF herunterladen (Seite 19)

z Page 19 July 28, 2005

19. Change the device code to represent the MX-700/800. Use 11 or pick a code that is not

used by your equipment.

20. Change the Function Codes to 1, 2, 3, and 4. The screen should look similar to the one

below:

21. Put the MX-700/800 in program mode by holding the MAIN and ENT keys for about 10

seconds until SETUP comes up. Then push LEARN.

22. Go into PGM-I and push WATCH. Remote says READY.

23. Click on the first item of the IR Configuration Tool (Scene Watch).

24. Hold the MX-700/800 as close as possible to the left side of the red window on the i-

PoRT-IRs. Programming will fail if the MX-700/800 is too far away.

25. Click on Menu bar: IR > Transmit IR code. The red LED on the i-PoRT-IRs will start

flashing.

26. The MX-700/800 says GOOD at the top of its screen and Saved at bottom. The red LED

will stop flashing and go off.

27. NOTE: If the remote does not say GOOD and Saved when you Transmit IR code, it did

not program the button. Hold the remote closer to the left side of the red window of the i-

PoRT-IRs and try transmitting again.

1 2 ... 14 15 16 17 18 19 20

Keine Kommentare

Universal Remote Control MX-800 Bedienungsanleitung Seite 19