Universal Remote Control MX-800 Bedienungsanleitung PDF herunterladen (Seite 20)

z Page 20 July 28, 2005

28. NOTE: MX-700/800 will go out of SETUP mode after a time. If it does, just hold MAIN

and ENT again to put it back into SETUP mode.

29. Go to PGM-I and push LEARN.

30. Click on the second item, Scene Learn, and click Menu bar: IR > Transmit IR code.

31. On the MX-700/800, push MAIN then ILINE then 1-ON.

32. Click on the third item, Turn on to 100%, and click Menu bar: IR > Transmit IR code.

33. On the MX-700/800, push 1-OFF.

34. Click on the fourth item, Turn off, and click Menu bar: IR > Transmit IR code.

35. After programming all the MX-700/800 buttons, write the macros from the IR

Configuration Tool to the i-PoRT-IRs (click Menu bar: IR > Write). IMPORTANT: Do not

push any keys on the MX-700/800 until the IR Write is finished. The window below

comes up. Watch the black screen near the bottom of the IR Configuration Tool window.

When it stops scrolling, the write is finished. This takes a minute or so.

36. Program a scene. Push MAIN, PGM-I, then WATCH on the MX-700/800. The LED on

the multibutton switch (device #4) will start flashing slowly indicating that it is in program

mode.

37. Turn dimmers #1 and #2 up to about 50%. Push LEARN on the MX-700/800. The LED

on the multibutton stops flashing. The scene is now programmed.

38. Turn off dimmers #1 and #2.

39. Activate the scene. On the MX-700/800, push MAIN, ILINE, and 1-ON. The dimmers

come up halfway. Push 1-OFF, the dimmers goes off.

Note to the User: The above example created a very simple scene involving only

two i-LiNE devices. Scenes can be programmed to involve many more i-LiNE

devices and other infrared equipment including TVs, stereos, etc. Refer to the i-

LiNE User Manual and the manuals for your equipment for detailed instructions on

scene programming.

1 2 ... 15 16 17 18 19 20

Keine Kommentare

Universal Remote Control MX-800 Bedienungsanleitung Seite 20