21 Does the Sonic Screwdriver have any lead paint on it?
No.
22 Having trouble with the rotation gestures?
A common problem with the rotation gestures is turning the Sonic Screwdriver
too fast, or drawing circles in the air. For the rotation gestures, you need to
rotate the Sonic Screwdriver very slowly and smoothly one quarter-turn,
keeping the tip steady, as if you were turning a volume knob. Once you've gone
just over a quarter-turn, the Sonic Screwdriver will register the rotation and go
into fine-resolution rotation mode, where it will register an event every 15
degrees - this allows you to control the volume with only small movements of
your wrist.
23 Trouble with the flick gestures?
A common problem with the flick gestures is waving the Sonic Screwdriver
around too vigorously or doing the opposite gesture at the beginning of your
intended gesture. If you're having difficulty with the flick gestures, stop and hold
the Sonic Screwdriver steady and horizontal for a couple of seconds before trying
again.
A short, positive flick of the wrist is all that is needed, where the tip of the Sonic
Screwdriver only moves a few centimetres (inches). Start the movement
pointing slightly away from the device you are controlling and finish the gesture
so the Sonic Screwdriver is pointing at the device.
24 Trouble with the tap gestures?
The Sonic Screwdriver should be held quite steady during the tap gestures. To
get started with these gestures, you might find it easiest to hold the Sonic
Screwdriver in one hand whilst tapping it on the knurled (criss-cross) areas with
one or two fingers of the other hand.
If you want to use your index finger to do a tap, remember that the Sonic
Screwdriver always knows which way is up so if you quickly rotate the Sonic
Screwdriver so that your index finger is at the side on underneath the Sonic
Screwdriver and then tap it, it will recognise this as a tap on the side or the
bottom.
25 Having difficulty programming your Sonic Screwdriver?
If you are having trouble programming your Sonic Screwdriver, check the
manual to make sure that you are entering programming mode correctly. To do
this press the Sonic Screwdriver button three times quickly, holding the third
press until the Sonic Screwdriver tells you that it is in programming mode. If you
can already get in to programming mode but are having difficulty learning codes
7
(25 Seiten)
(35 Seiten)
(319 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern