Universal Remote Control Thermo Control Bedienungsanleitung PDF herunterladen (Seite 9)

change channel in the same direction.

The Sonic Screwdriver can only learn the IR code it sees when the button is

pressed once during Programming Mode, which will be either code A or code B.

So, repeated gestures will send the same IR code each time, and that causes the

problem you're experiencing.

Fortunately, there is a work-around:

An undocumented feature of the Sonic Screwdriver is that you can actually learn

more than one remote control button onto each gesture (as a kind of macro) if

you press two buttons in quick succession whilst the Sonic Screwdriver is

glowing steadily green while in Programming Mode waiting to learn a code. This

very useful feature can help you deal with toggle codes by learning a dummy

code after each of the original toggle codes, in the following way:

While the Sonic Screwdriver’s tip is glowing green and it is waiting for a code,

first press the button on the original remote that you want to use (e.g. channel

up) and then quickly press another button on the original remote control which

has no effect (e.g. the yellow button on most TV remotes does nothing most of

the time), then the Sonic Screwdriver will learn two IR codes (e.g A,X) onto that

gesture.

Now when you perform repeated gestures for channel up (e.g. flick upwards), the

TV will receive code A (to change the channel up), then code X (which will do

nothing but make it forget that it had just received code A), then the next code A

(on the next flick upwards) should cause the channel to change again as

expected. It might take you a couple of attempts to get the timing right for

learning the "macro" of two buttons onto each gesture, but it's not too difficult

once you get the hang of it.

27 Need a long press to turn on the TV?

There are a few TVs (and other devices) which require a long button press to

turn them on or off. The Sonic Screwdriver can replicate a long button press by

use of its handle button. To do a long button press, double press the Sonic

Screwdriver handle button, holding the button down for the second press.

There are three memory banks and one long button press code may be stored on

the Sonic Screwdriver’s double button press gesture in each memory bank.

28 Problems with Windows Media Centre?

If you find that Windows Media Center will only respond once to a given

command from the Sonic Screwdriver and that repeated commands don't work,

please take a look at the explanation and solution given here:

http://www.cepro.com/article/no_more_quirky_ir_for_media_center/

1 2 3 4 5 6 7 8 9 10

Keine Kommentare

Universal Remote Control Thermo Control Bedienungsanleitung Seite 9