Universal Remote Control URC-SR3 Bedienungsanleitung PDF herunterladen (Seite 10)

Page 10

If the Three Digit Code did not

work, try this next:

Auto-Search Method

The Auto-Search Method is a way you can scan

through all of the codes in the table to find the right

code for your component.

STEP 1: Manually or using your old remote, turn

on the component you want to program—for

example, to program your TV, turn on your TV set.

STEP 2: On the URC-SR3, press the Component

button that you want to program (in this case the

button that says TV) and the SELECT [SEL] button at

the same time. Hold down both buttons for 2

seconds until the TV Component button light turns

on. This signals that you are in programming

mode.

IMPORTANT: You have 30 seconds to perform

the next step while you are in programming mode.

If you do not press a button within 30 seconds, the

component LED light will turn off. The remote will

exit the programming mode and you will have to

start over.

STEP 3: Point the URC-SR3 remote control toward

the component and press the UP



arrow (or

DOWN



arrow) button once. Each time the



or DOWN



arrow button is pressed, the

code will count up (or down) one code number

and send a Power OFF signal. When the correct

code is sent out, the component will turn off.

DOWN



ARROW



ARROW

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 43 44

Keine Kommentare

Universal Remote Control URC-SR3 Bedienungsanleitung Seite 10