Universal Remote Control RNC-200 Bedienungsanleitung PDF herunterladen (Seite 9)

RBS3202 Test with CMU300 and RNC/Iub SIM

1CM56_E 9 Rohde & Schwarz

• softkey Analyzer Settings: Set the DL frequency or channel

number to be used on the RNC simulator.

• softkey Exp. Pow. Trigger: Switch to manual control (mode:

Manual) and set the expected power approx. 13 dB (PEP) higher

than the maximum Node B output power set on the RNC. If the

message "Overload at connector RF1" occurs, increase the value

of the expected input power until the message ceases to occur.

• Carry out power measurement.

• Switch to modulation analysis (softkeys Menus / Modulation) and set

the activated DL test model (softkeys Analyzer Settings / Test Model).

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Keine Kommentare

Universal Remote Control RNC-200 Bedienungsanleitung Seite 9